Roll forming lines, special machines for sheet metal working and production of metal profiles

Brasileiro Deutsch Espanol Francais Italiano


This solution executes contemporarily the upper and lower sheets for the sandwich panels.
The upper sheet is almost always the same profile for walls (visible and hidden screw)and roof.
It has the possibility to change rapidly width (PMD with mobile supports) and rapid change of ribbing (drawing).
In option cassettes
Lower line, line for walls same as upper line with possibility change with cassettes for hidden screw (option n 2 separate roll forming lines).
Regarding the roll forming line for trapezoidal sheets there is a motorized device to make enter in line roof and wall roll forming lines.
As option there are double decoilers to change coil without stopping the line.

Attached images
Wall and roof panel
Detail of strip introduction zone
General view of machine initial part
Roll forming line
Ribbing heads
Unit to apply protective film
Detail of lower flying heading shear
Control desk
Technical data
Mechanical speed of the line ~15 m/min
Material galvanized, pre-painted
Material thickness (0,5)-0,6-0,8 mm
Decoilers capacity 10 t
Maximum width 1250 mm
Working height 1350 mm
Skype Me!Skype Me!
PM sas - Via Montegrappa 109 - 30030 Salzano (VENICE) - ITALY -- Tel. +39 0415745047 -- 45.535134;12.10876 P. IVA 02228830275