Roll forming lines, special machines for sheet metal working and production of metal profiles

Brasileiro Deutsch Espanol Francais Italiano


This very flexible line producing frame- and counter-frame profiles for reinforced doors has the following characteristics:
Introduction group to facilitate the strip introduction
Flexible strip punching unit to have the automatic change of the holes
Roll forming line with mobile supports to change quickly the bendings from frame to counter-frame.
Cutting saw with double disk at 45 and single disk at 90 to have the maximum flexibility with lengths.
Practically we have special software (parametric) to make in sequence a different door from another (makes right upright, traverse and left upright each time).

Attached images
Flexible roll forming line type PMD
Detail of frame at 45
Fram profile
Roll forming line detail
Cutting saw
Flexible strip punching unit
Drawing of the reinforced door frame
Drawing of reinforced door counter-frame profile
Flexible roll forming line type PMD
Detail of the rolls
Technical data
Decoiler capacity 5 t
Decoiler opening: hydraulic
Motorized AC decoiler with inverter kW
Maximum width 300 mm
Profiling heads 16 n
Roll forming line shaft 80 mm
Roll forming line DC motor
Max. material thickness 2,5 mm
Maximum profile length 3000 mm
Line direction to be determined
Line colour 5015 RAL
Skype Me!Skype Me!
PM sas - Via Montegrappa 109 - 30030 Salzano (VENICE) - ITALY -- Tel. +39 0415745047 -- 45.535134;12.10876 P. IVA 02228830275