Roll forming lines, special machines for sheet metal working and production of metal profiles

Brasileiro Deutsch Espanol Francais Italiano


The line for steps is a line which can produce steps like shown on the first page of this catalogue, basically two types, one with open and one with closed plane. The first one can be produced with widths of 200 mm or 250 mm, the second one with widths of 300 mm or 500 mm. The length of the products can vary from 500 mm minimum to 6000 mm maximum. For all products the material thickness is 2 mm. The line has a 5 t decoiler followed by a straightener feeder which supplies the material to the press with the punching units. The pre-sheared strip is sent to the roll forming line for the forming of the product and then to the bending and cutting dies. The line is completed with a manual marking unit with 15 interchangeable characters.
At the end of the line there is an unloading bench which brings the finished product out of the line.

Attached images
Example of finished products
Detail of bending and cutting die
Example of sections of products
View of the line
View of the line
Detail of pre-sheared product
Detail of press complete with dies
Control panel
Technical data
Decoiler capacity max 5 t
Int. coils 500 mm
Useful width max. 700 mm
Thickness 2 mm
Line speed 1,3 m/min
Material: Fe 400
Line colour to be determined
Line direction to be determined
Skype Me!Skype Me!
PM sas - Via Montegrappa 109 - 30030 Salzano (VENICE) - ITALY -- Tel. +39 0415745047 -- 45.535134;12.10876 P. IVA 02228830275