Roll forming lines, special machines for sheet metal working and production of metal profiles

Brasileiro Deutsch Espanol Francais Italiano


Description of line functioning:
The operator places the coil with the help of a crane or fork lift truck on the decoiler, cuts open the steel strip and inserts it between the first profiling passage (between the rolls). Then by impulses and not in automatic mode passes the strip along the whole roll forming line, taking care that there is no blockage. After that the strip is taken up to the cutting unit for the heading. After this operation the plant is switched over in automatic mode and will execute the various programmed operation until strip is finished.
After the cut we have a simple non motorized bench with rolls to support the profile. When the profile is cut, it slides laterally (one side only)through a pneumatic cylinder, liberating the space for another piece. On the control desk can be inserted the n of pieces and the length, which is controlled by an encoder, with metric wheel placed on the profile itself.

Attached images
Finished product
Section of products
View of the line
Detail series of rolls
Detail flying shear
Control panel
Technical data
Useful width roll forming line 200 mm
Material: Galvanized
Thickness 0.8 mm
Line colour 5015 RAL
Line direction Left-Right
Decoiler capacity 2 t
Int. coils 500 mm
Skype Me!Skype Me!
PM sas - Via Montegrappa 109 - 30030 Salzano (VENICE) - ITALY -- Tel. +39 0415745047 -- 45.535134;12.10876 P. IVA 02228830275